Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Community
The Round Table
The Official BoB 2016 Pipe of the Year thread.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Brothers of Briar:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Ozark Wizard" data-source="post: 465564" data-attributes="member: 3652"><p>I have a question for all you Falcon owners out there. I have yet to try this myself, as it just came to mind, but are all the threading jobs started at the same point? What I mean is, if a bowl is set to full center and marked, and then set on another stem, will it stop at the same center point? So say, I engrave a bowl centered on my stem, will it be centered on yours? Oh crap, hang on, I'll check and be right back.....</p><p></p><p>Ok, checked 4 bowls and four stems by building the pipes, then put a piece of masking tape over the seams. I made a center mark on them, then took a razor and cut the tape at the seams. Swapping bowl shows that all but the originally marked pair were off, some by as much as a quarter inch. </p><p></p><p>If someone else could try this and confirm, it would be good to know........</p></blockquote><p></p>
[QUOTE="Ozark Wizard, post: 465564, member: 3652"] I have a question for all you Falcon owners out there. I have yet to try this myself, as it just came to mind, but are all the threading jobs started at the same point? What I mean is, if a bowl is set to full center and marked, and then set on another stem, will it stop at the same center point? So say, I engrave a bowl centered on my stem, will it be centered on yours? Oh crap, hang on, I'll check and be right back..... Ok, checked 4 bowls and four stems by building the pipes, then put a piece of masking tape over the seams. I made a center mark on them, then took a razor and cut the tape at the seams. Swapping bowl shows that all but the originally marked pair were off, some by as much as a quarter inch. If someone else could try this and confirm, it would be good to know........ [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Community
The Round Table
The Official BoB 2016 Pipe of the Year thread.
Top