Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Pipes & Tobacco
DIY
Assistance in Building a Pipe Rack
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Brothers of Briar:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Eric Furgeson" data-source="post: 482366" data-attributes="member: 4025"><p>I set my stem rests 1 1/2 inches apart the holes are about 3/4 of an inch. As i used the largest sanding cylinder on my dermal tool. I can not give an exact size. I just sanded it out till a good sized stem fit in each. Th stem rest seti about 3 to 3.5 inches above the bowl shelf. There again i used the pipes I was going to place in the rack as my guide. Setting it at a hight that they would all fit in.</p></blockquote><p></p>
[QUOTE="Eric Furgeson, post: 482366, member: 4025"] I set my stem rests 1 1/2 inches apart the holes are about 3/4 of an inch. As i used the largest sanding cylinder on my dermal tool. I can not give an exact size. I just sanded it out till a good sized stem fit in each. Th stem rest seti about 3 to 3.5 inches above the bowl shelf. There again i used the pipes I was going to place in the rack as my guide. Setting it at a hight that they would all fit in. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Pipes & Tobacco
DIY
Assistance in Building a Pipe Rack
Top