Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Pipes & Tobacco
DIY
Flat Jaws for Lathe Chuck
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Brothers of Briar:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="user 3779" data-source="post: 453028" data-attributes="member: 3779"><p>The jaws I have are rounded jaws, I have used them with very good success. There are a couple little tricks here and there to make em work better. If something is out of balance try slowing down the lathe until you have removed a good amount of material so there is less rotational force.</p></blockquote><p></p>
[QUOTE="user 3779, post: 453028, member: 3779"] The jaws I have are rounded jaws, I have used them with very good success. There are a couple little tricks here and there to make em work better. If something is out of balance try slowing down the lathe until you have removed a good amount of material so there is less rotational force. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Pipes & Tobacco
DIY
Flat Jaws for Lathe Chuck
Top