Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Community
The Round Table
Looking for infomation and advice.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Brothers of Briar:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Eric Furgeson" data-source="post: 479658" data-attributes="member: 4025"><p>I have to admit I am counting on the Seattle Pipe Club name having a certain amount of "draw" that goes with it. That and the fact that we have several members who are either well know or on the rise within the piping cominunity. I think that will help as an "in" in a lot of ways. I am not looking at this as a profit venture but I do wish to break even. So that will help as well. I am hoping I can get our master blender Joe Lankford to attend as well as several of the artisen pipe makers we have in the club. We also have past national slow smoke champion Grag Watness as a member so I am hoping he can help with that. So I do have resources open to me I just need to figure out how best to utilize them.</p></blockquote><p></p>
[QUOTE="Eric Furgeson, post: 479658, member: 4025"] I have to admit I am counting on the Seattle Pipe Club name having a certain amount of "draw" that goes with it. That and the fact that we have several members who are either well know or on the rise within the piping cominunity. I think that will help as an "in" in a lot of ways. I am not looking at this as a profit venture but I do wish to break even. So that will help as well. I am hoping I can get our master blender Joe Lankford to attend as well as several of the artisen pipe makers we have in the club. We also have past national slow smoke champion Grag Watness as a member so I am hoping he can help with that. So I do have resources open to me I just need to figure out how best to utilize them. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Community
The Round Table
Looking for infomation and advice.
Top