Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Pipes & Tobacco
DIY
My one and only cob creation
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Brothers of Briar:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="stormwulf133" data-source="post: 396306" data-attributes="member: 2872"><p>Ok to everyone asking. I think it smokes fine. i have noticed no weird flavor etc. a the draw is a little too open but not too bad. To glue the antler in place i used elmers wood glue, and on the inside i covered that with pipe mud and put a hardwood plug in the bottom of the pipe and built that up with mud until it was the right height for the hole. the horn goes in about as far as the wood does on a regular MM pipe.</p></blockquote><p></p>
[QUOTE="stormwulf133, post: 396306, member: 2872"] Ok to everyone asking. I think it smokes fine. i have noticed no weird flavor etc. a the draw is a little too open but not too bad. To glue the antler in place i used elmers wood glue, and on the inside i covered that with pipe mud and put a hardwood plug in the bottom of the pipe and built that up with mud until it was the right height for the hole. the horn goes in about as far as the wood does on a regular MM pipe. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Pipes & Tobacco
DIY
My one and only cob creation
Top