Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Pipes & Tobacco
DIY
Opening the draw on a full bent stem?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Brothers of Briar:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Richard Hester" data-source="post: 177546" data-attributes="member: 809"><p>The best way I found to bend a stem is to use a heat gun which will also make it streaght once you get the desired bend simply run it under some cold water. Also be crefull on the bit you use they can get hot and break off in your stem and then you will really have to send it off for a new one.</p><p>Best Regards</p><p>Richard</p></blockquote><p></p>
[QUOTE="Richard Hester, post: 177546, member: 809"] The best way I found to bend a stem is to use a heat gun which will also make it streaght once you get the desired bend simply run it under some cold water. Also be crefull on the bit you use they can get hot and break off in your stem and then you will really have to send it off for a new one. Best Regards Richard [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Pipes & Tobacco
DIY
Opening the draw on a full bent stem?
Top