Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Pipes & Tobacco
General Pipe Discussion
Hope for a Bad Pipe Design to Smoke Well?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Brothers of Briar:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="DrumsAndBeer" data-source="post: 318624" data-attributes="member: 2403"><p>I have a few of those. My first pipe is very much the same way. If it's a design issue, there are some fine folks on this board who could probably fix it for you. </p><p></p><p>I would highly recommend drying your tobacco a bit more prior to smoking it and see what happens. With my bent pipes especially, I always keep pipe cleaners on hand when I sit down to smoke. I run them down the the stem almost to the bowl to absorb built up moisture during each smoke, mostly whenever the pipe starts to gurgle. With new pipes I continue to do this until I get a good cake built up in the bowl, at that point I usually find myself reaching for the cleaners less and less. I also notice that pipes that tend to get hot when smoking get less hot with a good cake. Other than that, try to smoke slower. </p><p></p><p>If this doesn't work, I would look for a pipe expert to adjust the airway for you some..</p></blockquote><p></p>
[QUOTE="DrumsAndBeer, post: 318624, member: 2403"] I have a few of those. My first pipe is very much the same way. If it's a design issue, there are some fine folks on this board who could probably fix it for you. I would highly recommend drying your tobacco a bit more prior to smoking it and see what happens. With my bent pipes especially, I always keep pipe cleaners on hand when I sit down to smoke. I run them down the the stem almost to the bowl to absorb built up moisture during each smoke, mostly whenever the pipe starts to gurgle. With new pipes I continue to do this until I get a good cake built up in the bowl, at that point I usually find myself reaching for the cleaners less and less. I also notice that pipes that tend to get hot when smoking get less hot with a good cake. Other than that, try to smoke slower. If this doesn't work, I would look for a pipe expert to adjust the airway for you some.. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Pipes & Tobacco
General Pipe Discussion
Hope for a Bad Pipe Design to Smoke Well?
Top