Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Pipes & Tobacco
General Pipe Discussion
Question about drillings in crazy shanks
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Brothers of Briar:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Sasquatch" data-source="post: 306600" data-attributes="member: 509"><p>Top pipe is drilled as any normal pipe I guess - where the two sections meet is where the airway goes through at an angle. </p><p></p><p>Bottom pipe is clearly not one piece of wood all the way so there's part of the secret. It might have been drilled from "outside" and repaired or camouflaged in some way, in each successive part of the bend, or more likely is that each piece was drilled out in a curve (this is a complex little boring device) and then assembled.</p></blockquote><p></p>
[QUOTE="Sasquatch, post: 306600, member: 509"] Top pipe is drilled as any normal pipe I guess - where the two sections meet is where the airway goes through at an angle. Bottom pipe is clearly not one piece of wood all the way so there's part of the secret. It might have been drilled from "outside" and repaired or camouflaged in some way, in each successive part of the bend, or more likely is that each piece was drilled out in a curve (this is a complex little boring device) and then assembled. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Pipes & Tobacco
General Pipe Discussion
Question about drillings in crazy shanks
Top